UC1284GB Setup Guide
Install the driver for the UC1284GB
1)
Power
on the computer and make sure that USB port is enabled and working properly;
2)
Plug
the UC1284GB into the USB port, and Windows will detect the IEEE1284 devices
and run the ADD NEW Hardware Wizard to assist you in setting up the new device.
Click next to continue.
3)
Insert
the included driver diskette into the
floppy drive and click on Next to continue,
click on Search for the best driver for your device and specify location
as drive A:;
4)
Windows
will detect eh driver U2PAR.inf and shows the USB to Parallel Port Converter
device. Click on Next to continue installation;
5)
When
Windows finishes installing the software required for the new USB to Parallel
converter, click on Finish;
1)
Turn
off your printer, plug the Centronics connector of the UC1284GB directly into
your printer, turn on the power to the printer;
2)
On
the computer, click on Start/ Setting/ Printers, then right click on icon of
the printer you have just connected to UC1284GB port (the printer should have
already installed through LPT port, and been verified working properly through
LPT port), choose Properties;
3)
In
the Printer Properties windows, click on Details tab, and click on the down
arrow next to the print to the following port test box, choose LPT2 (USB to
parallel port), click on Apply on the bottom of the windows;
4)
Click
on General tab and click on Print Test Page to verify the printer is working
properly through UC1284GB;
5)
Now
you are ready to run this printer.
1)
Unplug
the UC1284GB from the computer;
2)
Insert
the included driver diskette for UC1284GB into your floppy drive and run
Uninst.exe